Views: 30 Author: Site Editor Publish Time: 08-21-2021 Origin: Site
The spindle of the CNC engraving machine is a kind of electric spindle, which is mainly used in small and medium-sized engraving equipment, and has the functions of high-speed engraving, punching, and slot milling. In the process of using the CNC engraving machine, sometimes we encounter some CNC engraving machine spindle failure problems, how can we solve it? Leapion Laser has summarized 9 common spindle faults and solutions for everyone, as follows:
A. The drive setting is incorrect;
B. Check whether the cooling water is circulating;
C. There is a problem with the spindle (bearing damage);
D. If there is noise when installing the tool, it is normal, and tooling is not required to replace the tool.
A. Check whether the cooling water is circulating;
B. Check whether there is a problem with the bearing;
C. If the knife is noisy and no tool is normal, please change the tool.
A. Check whether the coolant pump is working normally;
B. Check whether the water is flowing, the water is separated from the joint of the main shaft, blow from one side to the other side of the steam gun or pierce the joint on the main shaft with a needle.
Check whether the motor cable has any AC end of the phase output UVW terminal.
A. It may be that the plug on the spindle is not connected well or the wire inside the plug is not in good contact, we need to check whether there is a problem with the wiring;
B. If it is confirmed that there is no problem, check whether the inverter has a signal or whether the inverter parameter setting is correct;
C. If it is confirmed that there is no problem, it may be that the stator coil of the spindle hardware has been burned out, and the coil needs to be returned to the factory for repair and replacement.
A. It may be that the starting time is too short. Properly extend the acceleration time before the spindle works, and start engraving after reaching the running speed;
B. It is also possible that the current protection is caused by the lack of phase of the spindle, which requires us to check whether the connection of the spindle motor is correct;
C. In addition, if water enters the main shaft or insufficient water cooling, it is easy to cause hardware failures and needs to be returned to the factory for repair.
A. Check whether the water circulation pipe is unobstructed;
B. Check whether the setting parameters of the inverter are correct, and reset the inverter;
C. If there is nothing wrong with these two items, it is possible that the inverter has no output voltage and the frequency is different from the rated voltage and frequency on the spindle nameplate. We need to check the reference frequency of the inverter.
Check whether the spindle rotation direction is wrong. If it is wrong, you need to change the rotation direction according to the mark on the spindle nameplate.
Basically, these problems are hardware problems. The bearing is worn out and the spindle has a big jump. It needs to be returned to the factory to replace the bearing or replace with a new spindle.
The above are some of the faults and solutions that often occur in the spindle of the CNC engraving machine. If there are other faults, it is best to contact the technical department of the CNC engraving machine manufacturer or the spindle supplier to solve it. If you want to know more about CNC engraving machine, please consult Leapion Laser. Leapion laser 7×24 hours online service.
