Fiber laser cutting machine for metal services industry

And this article is about the metal services industry's fiber laser cutting unit. Like the New Days. There are more and more consumers asking for a metal laser cutting unit. For this metal trimming, as we know. Choosing IPG and Raycus laser sources is more fitting. And here's this sort of computer sharing:

Primary portions

1.1 and the development of the European CE standard

1.2 Operating area as well: 1500mm*3000mm.

1.3 Type of laser: 1000W E-LIGHT

1.4 Fiber laser generator: laser cutting head from Raytools

In addition, 1.5, Water-cooling system: Tongfei brand, China's highest quality

1.6 Type of transmission: Dual drive

1.7 and Engine: Japan YASKAWA YASKAWA Servo Engine Moving Engine (X axis 850w, Two Y axis each of them is 1300w , Z axis 400w ).

1.8 System body at the same time: New form of lathe bed plate welding type:

1.9 and Control System: Cypcut Shanghai Control System Cypcut

1.10 Rail: HIWIN/PMI/ABBAA/ABBA In addition to 1.11, the X axis and Y axis dust hood and the laser head.

1.12 Working Table Cross Sliding Rack.

So if you are interested in this machine or have any other questions after providing so much detail, please contact us.

To guarantee synchronization and prevent interfering with the signal. Based on electrical science, we use the following steps .

The main circuit and control circuit are independently bypassed by wires. The main controller cable uses shielded or twisted wire.

Separate outlets are used to connect the motor and driver to prevent being parallel to other wires. Chip to I/O interface, controller. The sensor and the connector are as similar as possible. The upper wire connects. The Aerial plug connector and Weidmuller terminal block are used for the main and lower appliances.