Article List

• The difference between lubricants for linear guides

  Lubricants for rails are divided into three categories: (1) Rail oil (slide oil)(2) Dual-purpose oil for hydraulic rails (3) Grease. The most important characteristics of rail oil are its strong adhesion and water washout resistance, as well as extremely strong resistance to extreme pressure.

  Laser Cutting Machine Blog August 09, 2022
• Feedback from Italian customers

  CO2 laser Machine in customer factory in Italy

  Customer Feedback August 08, 2022
• Leapion 2022 Summer Team Tour to Yantai

  Company News July 29, 2022
• Customer Feedback from India

  Fiber Laser Cutting Machine in customer factory in India

  Customer Feedback August 03, 2022
• The difference between traditional co2 metal cutting machines and fiber laser cutting machine

  Leaping machinery has been engaged in the application field of high-power laser technology. At present, the laser cutting machines used for material cutting can be roughly divided into two types: fiber laser cutting machines and CO2 laser cutting machines. As the mainstream traditional laser cut

  Laser Cutting Machine Blog July 26, 2022
• Alternative Advantages of ‘Laser Metal Cleaning’ to ‘Metal Pickling’

  A pickling board is an intermediate product with the high-quality hot-rolled sheet as raw material, after removal of the oxide layer, trimming, and finishing by the pickling unit, the surface quality, and usage requirements are between those of a hot-rolled sheet and cold-rolled sheet. Under th

  Laser Cleaning Machine Blog August 05, 2022
• Feedback from customers in Argentina

  Fiber Laser Cutting Machine in Argentina customer factoryOn-site cutting pictures

  Customer Feedback August 01, 2022
• The advantages of SMC pneumatic components compared to other brands

  The advantages of SMC pneumatic components compared to other brands Pneumatic components are performing work through the pressure or the force generated by gas expansion, that is, the components that convert the elastic energy of compressed air into kinetic energy. Such as cylinders, air motors, ste

  Laser Cutting Machine Blog August 04, 2022
• The difference between linear motor and "ball screw + servo motor"

  The linear motor was invented by the British in 1845, but the air gap of the linear motor at that time was too large and the efficiency was very low, so it could not be applied. After the 1970s, Kollmorgen was also launched, but its development was limited due to high cost and low efficiency. It

  Laser Cutting Machine Blog August 02, 2022
• The difference between the servo motor and stepper motor

  1. How to choose stepper and servo motors? It mainly depends on the specific application situation. In short, it is necessary to determine: the nature of the load (such as horizontal or vertical load, etc.), the requirements for torque, inertia, speed, accuracy, acceleration, and deceleration, and t

  Laser Cutting Machine Blog July 28, 2022