Views: 63 Author: Site Editor Publish Time: 08-31-2021 Origin: Site
Nowadays, laser cutting machines have been widely used in the processing and manufacturing of various metal materials. However, the laser cutting machine is a relatively precise instrument. If there is a slight error, it will have a certain impact on the cutting product, such as the sawtooth phenomenon during cutting. So, how to solve the sawtooth in laser cutting machine cutting? Let’s share with you Leapion laser below.
Any phenomenon has certain reasons. We must first understand why the laser cutting machine cuts with sawtooth? Then solve the problems one by one according to the specific reasons.
If the laser cutting machine vibrates, the products it cuts will have jagged. It is divided into two reasons:
1) One is the external situation of the laser cutting machine. For example, during the cutting process of the laser cutting machine, will the water tank and the ventilation opportunity be too close? If you are too close to the machine tool, it will vibrate the machine tool when it is running, and when the laser cutting machine is cutting the material, it will vibrate, which will affect the edge effect of the cutting.
2) Another reason is caused by vibration in control. If the motor is not running smoothly, etc., this problem can also be caused.
3) Another reason is that if the laser cutting machine is not adjusted well, it will also happen. Such as the machine's operating acceleration, or take-off speed, etc., if it is not set, then it will also happen.
Sometimes, if the lens is not locked, the lens will also vibrate when the laser cutting machine is running, and the light will also vibrate when the laser cutting machine is cutting, so the cut product will not have a good effect, and there will be jagged happen.
If the parallelism of the laser cutting machine is not installed properly, it will not be stable when the laser cutting machine is running. Then, it will jitter during its operation, and the cut products will also be born with sawtooth.
If the edge of the gear seat is close to the seat, causing slippage, it can also cause this situation.
1) Check whether the parameter is written incorrectly:
When the speed value of the laser cutting machine is too large, the material will not be completely heated, and the cutting surface of the material will appear jagged. At this time, adjust the speed value parameter appropriately.
2) Check if it is caused by graphic output or computer input
If the graphic input of the laser cutting machine is wrong, you can redraw the graphic at this time, or replace the computer.
3) Check whether there is a gap between the headstock of the trolley and the slider:
If there is a gap, you need to readjust the slider at this time to make the slider in the proper position.
4) Check whether the moving parts of the machine are loose: At this time, check the relevant parts one by one.
5) Check whether the timing belt is too loose or too tight: If there is an abnormality, you need to adjust the timing belts on both sides to make the timing belts the same tightness.
6) Check whether the beams are parallel: If the beams are not parallel, correct the parallelism and reduce the error.
7) Check whether the motherboard or driver is caused by failure: If there is a fault, replace the motherboard or driver.
The above is how to solve the problem of sawtooth when the laser cutting machine is cutting. If you encounter a similar situation during the use of the laser cutting machine, it is recommended that you first repair and inspect it before processing and production to avoid unnecessary situations. For more professional questions about laser cutting machines, please consult Leapion Laser.
