How to maintain and maintain the laser cutting machine in the high temperature in summer

In summer, the temperature rises in various places, and many laser equipment will generate heat during use, which will cause some failures. Therefore, in order to avoid the failure of the laser cutting machine in the summer, everyone must pay attention to the maintenance and repair of the laser cutting machine, which can extend the service life of the machine.

During the hot summer, Big Picture Laser reminds you that whether it is going out to play or working outdoors, take measures to prevent heatstroke. We must not only prepare for heatstroke prevention and cooling, but also do maintenance for the laser cutting machine to prevent the machine from "heatstroke"

Water cooling

In hot weather, the deterioration rate of the cooling water will also increase. It is recommended that users of the laser cutting machine use regular distilled or pure water and clean up the scale regularly to avoid the adhesion of scale in the laser and pipes that affects the laser power; pay attention to the temperature of the cooling water not to differ from the air temperature Too big. As the summer temperature gets higher and higher, the working pressure of the cooling system of the laser cutting machine increases sharply. It is recommended to check and maintain the internal pressure of the cooler before the high temperature comes, and adjust it to adapt to the high temperature in time.

Lubrication

The guide rails should be cleaned frequently to remove dust and other debris to ensure that the laser equipment is normal. The rack should be wiped frequently and lubricated. The time should be adjusted to shorten the time by 0.5-1 times compared with the spring and autumn season, and keep observation Oil condition. For machinery working in high-temperature areas, appropriately increase the viscosity level of the oil, and the temperature of the fat oil is easy to change. Add oil appropriately to ensure lubrication without debris. Carefully check the cutting table of the laser cutting machine and the straightness of the track and the verticality of the machine, and if it is found to be abnormal, it will be maintained and adjusted in time. The guide rail should be cleaned and lubricated frequently, and the motor should be cleaned and lubricated frequently to keep the machine in the best condition at all times. The machine can move better during operation, and cut more accurately. The product quality will be higher.

Line

Check and replace the aging wires, plugs, hoses, and connectors; check whether the connector pins of the electrical components are loose, and tighten them in time to avoid poor contact causing electrical appliances to burn out and signal transmission unstable.

Contact : June
Wechat/WhatsApp:+86 1553149513
Email: june@leapion.com